• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        WESTERN BLOTTING USING CHEMILUMINESCENCE

        互联网

        2383

         

         

         

        REAGENTS

         

         

        ECL Western blotting kit (Amersham Life Science; cat# RPN2108): contains second antibodies for both mouse and rabbit, substrate and milk blocker (the milk blocker is not normally used when using ruminant samples).

        Hybond ECL nitrocellulose membrane (Amersham Life Science; cat # RPN2020D)

        Kodak X-OMAT (XAR-5, 18X24 cm; cat # 8532665)

         

        10X TBS

        12.11 g Tris-base (100 mM)

        87.66 g NaCl (1500 mM)

        1 liter dd H2 O

        Adjust pH= 7.6

        Washing buffer (TBS-T): 100 ml 10X TBS + 900 ml dd H2 O + 1 ml Tween-20.

        Blocking buffer: TBS-T + 1.5% gelatin

        Incubation buffer I (for first antibody): TBS + 1.5% gelatin

        Incubation buffer II (for second antibody) = blocking buffer (i.e., TBS-T + 1.5% gelatin)

         

        PROCEDURES

        1- Immediately after removal from the blotting apparatus, place membranes into blocking buffer for 2 hours. A small plastic gel box is a suitable container. This and all other incubation steps are performed at room temperature and in the rocker platform.

        2- Wash membrane in washing buffer: rinse 2 times very briefly, incubate for 15 minutes, then repeat 2 x at 5 minutes each. Use a lot of buffer.

        3- Transfer the membrane to a lid of 96-well microtiter plate or similar low volume container. Incubate with first antibody using recommenced dilution in TBS + 1.5% gelatin during 2 hours. Approximately 10 ml of diluted antibody showed to be sufficient.

        4- Transfer the membrane into gel box and repeat step # 2.

        5- Transfer the membrane back to the small container and incubate with anti-mouse or anti-rabbit IgG horseadish peroxidase diluted 1:8000 in TBS-T + 1.5% gelatin for 1 hour.

        6- Repeat step # 4 (wash)

        7- Prepare ECL solution for detection: mix equal volume of ECL reagent 1 and 2, (1:1) with final volume regarding of 0.125 ml/cm2 (for a mini gel- 4 ml of each reagent).

        8- Remove excess buffer from the membrane by draining the membrane over a piece of folded kimwipe paper and briefly touching the edge of the membrane to the paper.

        9- Add ECL solution and incubate for 1 minute.

        10- Repeat step # 8 ( drain excess of substrate)

        11- Place membrane down on seran wrap, remove bubbles and wrap membrane completely.

        Avoid excess amounts of seran wrap.

        12- Tape membrane to the inside film cassette.

        13- In the dark, add 1 sheet of x-ray film to the cassette. Expose membrane to film. It will probably be necessary to do several different exposures to find out the best exposure.

        14- Develop the film.

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序