• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        PCR产生非特异条带

        互联网

        3927

        Possible Causes: Components 可能原因之一——反应组分

        · Primer concentration is too high.

        · Primer degeneracy is too high.

        · Nested primers are required.

        · New primers are required. Some primers are immune to optimization and it's possible that your primers are good matches to other sites in addition to the desired template. See Primer Design.

        · Template denaturation efficiency is too low.

        · Mg++ concentration is too high. Try decreasing the Mg++ concentration by 0.2 mM increments.

        · dNTP concentration is too high.

        · Polymerase concentration too high.

        · pH is suboptimal. Check at higher and lower levels.

        Possible Causes: Conditions 可能原因之二——反应条件

        · Annealing temperature is too low, causing mispriming. Try using a much higher annealing temperatures , especially in the first few cycles.
        · Cycles periods are too long.

        · Too many cycles. Compare the number of bands and their relative amounts after fewer cycles. There may be excessive template if proportionally more of the intended product is present at the earlier cycles.

        · Ramp speed is too slow. Check your thermocycler

        specifications

        · Inhibitors are present and/or concentrations are too high. See About Inhibitor

        · Enhancers are required. See About Enhancers.

        · Contaminants are present. See How to Reduce Contamination.

        · Hot Start or Touchdown PCR is required.

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序