检测细胞谷胱苷肽含量

Glutathione^- a microassay for determining glutathione content in cells 检测细胞谷胱苷肽含量

Laboratory of P.J.Hansen,Dept.of Animal Sciences,University of Florida

http://www.animal.ufl.edu/hansen/protocols/gsh.htm

The following assay is modified from that developed by Baker et al.(Anal.Biochem.190,360,1990).See that paper for more details of the principle of the method.

Materials (from Sigma)

NADPH,pre-weighed vials (N 7505)

DTNB (D 8130)

GSH reductase,from bakers yeast (G 3664)

GSH,free acid (G 6529)

Prepare in Advance

1.100 mM NaPO₄ buffer,pH 7.5 w/ 1 mM EDTA.Store @ room temperature.

2.1 mM DNTB.Store frozen in 5 ml aliquots.

3.Glutathione reductase.Dissolve in buffer to 200 U/ml and store @ 4℃.

Final concentration (pmol/well)	microliters of 4 nmol/ml stock	microliters of water
200	use stock undiluted
100	100	100
50	50	150
25	25	175
12.5	12.5	187.5
6.75	12.5	387.5
3.375	100 microliters of 6.75 stock	100
1.6875	50 microliters of 6.75 stock	100

4.Reaction mixture: Mix 5 ml of DNTB,5 ml of NADPH,5.75 ml of buffer and 0.1 ml of GSH reductase.

Assay

1.Use 96-well plates.Pipette 50 µl sample or standard into each well (don't forget a blank w/ 50 µl water).

2.Add 100μl reaction mixture.

3.Place plate in microtiter plate reader immediately.Set to read @ 405 nm,repeat read @ 2 minute intervals.

Use with Embryos

1.Store embryos in minimal volume (~5 µl)in water at 20℃

2.For assay,add 5 µl (or same volume as embryos are in)1.25 M phosphoric acid to well of 96-well microtiter plate.Add embryos to this well and then add 40 µl water and 100 µl reaction mixture.

3.Use standards down to ~0.15 pmol.

4.Use blank with proper amt of phosphoric acid.

Notes on Use of The Protocol

1)We have used the procedure for RBCs and embryos.The procedure as attached uses standards for the RBC assay.For embryos,you need more standards < 1 pmol and less of the higher standards.

2)We try to collect 10 or more embryos per assay determination.The number of embryos needed to get detectable GSH varies with stage of development (GSH decreases as development proceeds).We try to collect these in as small a volume as possible using a wiretrol and then bring to 5 µl with water and store at 20℃ Then for the assay,we mix the embryos with 5 µl H₃PO₄ .Sometimes,we need to collect embryos from more than one drop and then final volume may have been greater than 5 µl.We record the volume and add the same volume phosphoric acid.

3)We do the assay in a microtiter plate reader that has a repeated-reads function (i.e.,we can measure absorbance at standard time intervals).We usually pick the time point giving best standard curve retrospectively from each assay.If you want to read absorbance at only one time,you will need to play around with optimal incubation times.