• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        几种DNA定量方法

        互联网

        2436

         

        Quantitation of DNA

        Fluorescent quantitation

        Wear gloves and goggles protecting from EtBr and UV light

        With an EDP (dilute mode) pick up 9 µl TE and 1 µl vortexed DNA sample. Spot this on a place of scrap parafilm, pull it up and down one time, and make a second 10 fold dilution with 9 more µl TE and 1 µl of the first dilution. Spot 5 µl of these dilution on different parts of an EtBr agarous (in TBE with EtBr same as a gel) plate (label the bottom of the plate), if the concentration of the original DNA sample is suspected to be less than 20 µg/ml, then spot 5 µl of the undiluted sample also. Also spot on the plate 5 µl of at least the 2, 5, 10, 15, and 20 µg/ml DNA standard. Let the liquid soak in and invert the plate on the transilluminator and compare, interpolate, and record the unknown spots for fluorescent intensity to the standard. Use the dilution that gives between 2 and 20 µg/ml reading. Back calculate the amount of DNA by the dilution factor. It is best if the sample spots are coded and some one else reads them.

        DPN Assay quantitation

        Care of handling perchloric acid and DPN

        1. In a fume hood, place the following reagent in a MFT
            Stock Volume (µl)
            H2O   140
            DNA    10
          3N perchloric acid 150
            DPA solution  180
          
          
          Cap the tubes and mix by inversion.
        2. Incubate in the dark overnight at room temperature. Note the incubation time for use in the future when repeating the procedure. A calibration curve then will not be necessary each time.
        3. Read the optical density at 600 nm and compare with a calibration curve made from measurements with a standardized DNA solution. The curve is only linear between the concentrations of 5 - 50 µg/ml: dilution may be necessary for more concentrated solutions.

          3 N perchloric acid : dilute 49.2 ml perchloric acid up to 200 ml with H2O in a hood.

          DPA (diphenylamine) solution : In a hood, add 20 µl paraldehyde to 198 ml of glacial acetic acid in 250 ml Erlenmyer flask. With gloves, carefully weigh out 8 g of DPA and add to the above solution, quickly cover with foil, and shake until dissolved. Store in the dark in a fume hood. This solution is stabe for 6 weeks.

         

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序