• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        E.Z.N.Z.TM MicroElute RNA Desalting and Concentration protocol

        互联网

        1567

        实验步骤

         

        1. Measure the volume of sample and transfer into a new 1.5 ml microcentrifuge tube. Adjust the sample volume to 100ul with DEPC-Water and proceed to step 2.

        Note: if the starting samples is RNA pellet, dissolve the samples with DEPC treated water.

        2. Add 350ul QVL Lysis buffer and mix by vortexing. When process small amount of RNA (?2 ug). Add 2 ul of Linear Acrylamide to the mixture.

        Note: Remember to add 20 ul of 2-mercaptoethanol per 1 ml of QVL Lysis Buffer before use.

        3. Add 250 ul absolute ethanol (96-100%, room temperature) to the sample and mix thoroughly by vortexing.

        4. Apply sample from step 3 to HiBind® MicroElute RNA column inserted in a 2 ml collection tube (supplied). The maximum capacity of the spin cartridge is 700 ul. (Larger volumes can be loaded successively.) A precipitate may formupon addition of ethanol in Step 3. Vortex and add the entire mixture to the column. With the spin column inside a 2ml collection tube (supplied with kit), centrifuge at 10,000 x g for 30 seconds at room temperature. Discard flowthrough and re-use the collection tube.

        5. Place column in the same 2 ml collection tube from step 4 and add 500 ul RWB Wash Buffer diluted with absolute ethanol. Centrifuge and discard flowthrough.

        Note: RWB Wash Buffer Concentrate must be diluted with absolute ethanol before use. Refer to label on bottle for directions.

        6. Place column back into the same collection tube from step 5, and add another 500 ul RWB Wash Buffer diluted with absolute ethanol. Centrifuge and discard the flow-through and collection tube.

        7. Place the column into a new 2 ml collection tube (supplied). Centrifuge the column at full speed ($13,000 x g) for 2 minutes. Discard the flow-through and the collection tube.

        8. Elution of RNA. Transfer the column to a clean 1.5 ml microfuge tube (not supplied with kit) and pipet 15-30 ul of DEPC-treated water (supplied with kit) into the column. Make sure to add water directly onto center of column matrix. Incubate at room temperature for 2 min. Centrifuge for 1 min at maximum speed. A second elution may be necessary if the expected yield of RNA >20 ug.

        Alternatively, RNA may be eluted with a smaller volume of water. While reduced elution volume reduce the RNA yield, the concentration will be higher since more than 80% of RNA is recovered with the first elution. Pre-heating the water to 65°C before adding to column and incubating column 2 min at room temperature before centrifugation may increase yields. Elution with less than 10ul volume is not recommended.

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序