相关产品推荐更多 >
万千商家帮你免费找货
0 人在求购买到急需产品
- 详细信息
- 技术资料
- 库存:
35
- 英文名:
Cereblon modulator 1
- CAS号:
1860875-51-9
- 供应商:
上海莼试
- 保存条件:
Store at -20°C
- 规格:
5mg 10mg 25mg 50mg 100mg
商品属性:
产品描述:
分子式:C22H18ClF2N3O4

分子量:461.85
溶解度:DMSO: 250 mg/mL (541.30 mM)
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
A different CRBN-binding compound, Cereblon modulator 1 (compound F), that demonstrates anti-proliferative activity in non-AML hematological cancer cell lines (such as multiple myeloma) does not inhibit cell growth in any of the 11 AML cell lines tested, including the ten cell lines that are sensitive to the growth inhibitory activity of Compound D. However, when excess Cereblon modulator 1 is added to KG-1 AML cell cultures in the presence of Compound D, the anti-proliferative activity of Compound D is reduced, presumably due to competition for binding of Compound D to CRBN. The relative impact of Cereblon modulator 1 on the anti-proliferative effect of Compound D progressively increased with increasing concentrations of Cereblon modulator 1. In the presence of 100 μμ Cereblon modulator 1, the potency of Compound D in inhibiting cell growth reduced by approximately 60-fold, and the potency of Compound D in inducing apoptosis reduced by approximately 40-fold[1].[1]. Ellen Filvaroff, et al. Methods for treating cancer and the use of biomarkers as a predictor of clinical sensitivity to therapies. WO2017120446A1. [2]. CC-90009
注意事项:
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
使用方法:
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
公司正在出售的产品:
| 货号 | CS-01Y65591 | 规格 | 5mg 10mg 25mg 50mg 100mg |
| CAS号 | 1860875-51-9 | 分子量 | 461.85 |
| 含量 | >99.00% | 别名 | N/A |
| 分子式 | C22H18ClF2N3O4 | 化学名 | N/A |
| 产地 | 国产 | 用途 | 仅供科研研究实验 |
分子式:C22H18ClF2N3O4

分子量:461.85
溶解度:DMSO: 250 mg/mL (541.30 mM)
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
A different CRBN-binding compound, Cereblon modulator 1 (compound F), that demonstrates anti-proliferative activity in non-AML hematological cancer cell lines (such as multiple myeloma) does not inhibit cell growth in any of the 11 AML cell lines tested, including the ten cell lines that are sensitive to the growth inhibitory activity of Compound D. However, when excess Cereblon modulator 1 is added to KG-1 AML cell cultures in the presence of Compound D, the anti-proliferative activity of Compound D is reduced, presumably due to competition for binding of Compound D to CRBN. The relative impact of Cereblon modulator 1 on the anti-proliferative effect of Compound D progressively increased with increasing concentrations of Cereblon modulator 1. In the presence of 100 μμ Cereblon modulator 1, the potency of Compound D in inhibiting cell growth reduced by approximately 60-fold, and the potency of Compound D in inducing apoptosis reduced by approximately 40-fold[1].[1]. Ellen Filvaroff, et al. Methods for treating cancer and the use of biomarkers as a predictor of clinical sensitivity to therapies. WO2017120446A1. [2]. CC-90009
注意事项:
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
使用方法:
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
公司正在出售的产品:
| Recombnant Human CD4 proten | DNAJC5B蛋白封闭多肽 |
| 胞外分泌型丝氨酸/苏氨酸蛋白激酶FAM20C封闭多肽 | HRG1 Antibody Blocking Peptide |
| 6号染色体开放阅读框140封闭多肽 | MTMR9 Antibody Blocking Peptide |
| BCL2相关X蛋白封闭多肽 | KPNA3 Antibody Blocking Peptide |
| PHD指蛋白21A封闭多肽 | DENN Antibody Blocking Peptide |
| 嗅觉受体5V1封闭多肽 | LYVE-1 Antibody Blocking Peptide |
| 自噬相关蛋白8A封闭多肽 | HTR2B Antibody Blocking Peptide |
| 异柠檬酸脱氢酶1封闭多肽 | 磷酸化粘着斑激酶封闭多肽 |
| 神经调节蛋白1β2封闭多肽 | IDH1 Antibody Blocking Peptide |
| 肌微管素相关蛋白9封闭多肽 | APG8A Antibody Blocking Peptide |
| 死亡结构域接头蛋白DENN封闭多肽 | OR5V1 Antibody Blocking Peptide |
| KPNA3蛋白封闭多肽 | BHC80/PHF21A Antibody Blocking Peptide |
| 淋巴管内皮透明质酸受体封闭多肽 | Cereblon modulator 1Bax beta Antibody Blocking Peptide |
| 5-羟色胺受体2B封闭多肽 | C6orf140 Antibody Blocking Peptide |
| DNAJC5B Antibody Blocking Peptide | FAM20C Antibody Blocking Peptide |
风险提示:丁香通仅作为第三方平台,为商家信息发布提供平台空间。用户咨询产品时请注意保护个人信息及财产安全,合理判断,谨慎选购商品,商家和用户对交易行为负责。对于医疗器械类产品,请先查证核实企业经营资质和医疗器械产品注册证情况。
技术资料暂无技术资料 索取技术资料
Cereblon modulator 1
¥600 - 3200








