相关产品推荐更多 >
万千商家帮你免费找货
0 人在求购买到急需产品
- 详细信息
- 技术资料
- 库存:
29
- 英文名:
Lyso-Globotriaosylceramide (d18:1)
- CAS号:
126550-86-5
- 供应商:
上海莼试
- 保存条件:
Store at -20°C
- 规格:
1mg
产品描述:
分子式:C36H67NO17

分子量:785.9
溶解度:Chloroform:Methanol:Water (4:3:1): Soluble
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
Lyso-globotriaosylceramide is a form of globotriaosylceramide that is lacking the fatty acyl group. It binds to Shiga toxin 1 (Stx1) in the presence of cholesterol and phosphatidylcholine but does not bind Stx2. It also reduces viability and aggregation of human neutrophils induced by phorbol 12-myristate 13-acetate when used at concentrations of 50 and 1 μM, respectively. Lyso-globotriaosylceramide accumulates in the brain, heart, kidney, liver, lung, and spleen in a mouse model of Fabry disease, a lysosomal storage disorder characterized by a deficiency in the enzyme α-galactosidase A. It also accumulates in the urine, kidney, and plasma of patients with Fabry disease. Lyso-globotriaosylceramide levels decrease in response to administration of the α-galactosidase inhibitor 1-deoxygalactonojirimycin in a transgenic mouse model of Fabry disease. Decreases in plasma and urine concentrations of lyso-globotriaosylceramide have been used as a biomarker for efficacy of enzyme replacement therapy (ERT) and other therapies in the treatment of Fabry disease
商品属性:
注意事项:
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
公司正在出售的产品:
使用方法:
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
分子式:C36H67NO17

分子量:785.9
溶解度:Chloroform:Methanol:Water (4:3:1): Soluble
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
Lyso-globotriaosylceramide is a form of globotriaosylceramide that is lacking the fatty acyl group. It binds to Shiga toxin 1 (Stx1) in the presence of cholesterol and phosphatidylcholine but does not bind Stx2. It also reduces viability and aggregation of human neutrophils induced by phorbol 12-myristate 13-acetate when used at concentrations of 50 and 1 μM, respectively. Lyso-globotriaosylceramide accumulates in the brain, heart, kidney, liver, lung, and spleen in a mouse model of Fabry disease, a lysosomal storage disorder characterized by a deficiency in the enzyme α-galactosidase A. It also accumulates in the urine, kidney, and plasma of patients with Fabry disease. Lyso-globotriaosylceramide levels decrease in response to administration of the α-galactosidase inhibitor 1-deoxygalactonojirimycin in a transgenic mouse model of Fabry disease. Decreases in plasma and urine concentrations of lyso-globotriaosylceramide have been used as a biomarker for efficacy of enzyme replacement therapy (ERT) and other therapies in the treatment of Fabry disease
商品属性:
| 货号 | CS-01Y68302 | 规格 | 1mg |
| CAS号 | 126550-86-5 | 分子量 | 785.9 |
| 含量 | >98.00% | 别名 | N/A |
| 分子式 | C36H67NO17 | 化学名 | N/A |
| 产地 | 国产 | 用途 | 仅供科研研究实验 |
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
公司正在出售的产品:
| Recombnant Human CHRNB2, N-H | phospho-MAPK14 (Tyr323) Antibody Blocking Peptide |
| Recombinant Human Bcl10 | Recombinant Human RAP1B |
| ZNF680 Antibody Blocking Peptide | Recombinant Human Rap2A |
| PROX2 Antibody Blocking Peptide | Recombinant Human RBM3 |
| Phospho-CHK2 (Ser28) Antibody Blocking Peptide | Recombinant Human RAP2B |
| AAV5 capsid VP2 protein Antibody Blocking Peptide | Recombinant Human RBP2 |
| MSX2 Antibody Blocking Peptide | Recombinant Human RBP4 |
| GAS7 Antibody Blocking Peptide | 富含丝氨酸精子发生相关蛋白2封闭多肽 |
| SLC35E1 Antibody Blocking Peptide | Recombinant Human RAP1A |
| SEMG2 Antibody Blocking Peptide | Recombinant Human RANK |
| PDP1 Antibody Blocking Peptide | Recombinant Human RAMP3 |
| MIDN Antibody Blocking Peptide | Recombinant Human Rad6 |
| 1-(2-aminoethyl)-1H-pyrazol-4-ylphosphonic acid-OVA | Lyso-Globotriaosylceramide (d18:1)Recombinant Human RABIF |
| ACE1 Antibody Blocking Peptide | Recombinant Human Putative 40S ribosomal-like |
| phospho-NEDD9 (Ser369) Antibody Blocking Peptide | Recombinant Human PTRHD1 |
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
风险提示:丁香通仅作为第三方平台,为商家信息发布提供平台空间。用户咨询产品时请注意保护个人信息及财产安全,合理判断,谨慎选购商品,商家和用户对交易行为负责。对于医疗器械类产品,请先查证核实企业经营资质和医疗器械产品注册证情况。
技术资料暂无技术资料 索取技术资料
Lyso-Globotriaosylceramide (d18:1)
¥600 - 3200








