相关产品推荐更多 >
万千商家帮你免费找货
0 人在求购买到急需产品
- 详细信息
- 技术资料
- 库存:
48
- 英文名:
Moclobemide (Ro 111163)
- CAS号:
71320-77-9
- 供应商:
上海莼试
- 保存条件:
Store at -20°C
- 规格:
10mM (in 1mL DMSO) 10mg 50mg
产品描述:
分子式:C13H17ClN2O2

分子量:268.74
溶解度:≥ 9.85 mg/mL in DMSO, ≥ 48.3 mg/mL in EtOH with ultrasonic
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
Moclobemide is a reversible inhibitor of monoamine oxidase-A (MAO-A) with IC50 value of 10μM [1].Moclobemide is a prototype of RIMA agents. It is found to possess antidepressant efficacy with less risk of fatal side-effects like hypertensive crisis. Moclobemide shows a weak but specific inhibition of MAO-A in the in vitro assay using rat brain homogenates. The IC50 values of MAO-A and MAO-B in the assay are 6mM and 1000mM, respectively. In ex vivo animal experiments, moclobemide produces an inhibition of 80% in the brain and liver. Additionally, the long-term administration of high doses of moclobemide is found to down-regulate β-adrenoceptors and increase the agonist binding affinity of α1-adrenoceptors. Moreover, moclobemide is rapidly and almost completely absorbed after oral administration. The bioavailability of moclobemide is about 50% after a single administration of 100 mg
商品属性:
注意事项:
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
公司正在出售的产品:
使用方法:
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
分子式:C13H17ClN2O2

分子量:268.74
溶解度:≥ 9.85 mg/mL in DMSO, ≥ 48.3 mg/mL in EtOH with ultrasonic
储存条件:Store at -20°C
General tips:For obtaining a higher solubility , please warm the tube at 37 ℃ and shake it in the ultrasonic bath for a while.
Shipping Condition:Evaluation sample solution : ship with blue ice All other available size: ship with RT , or blue ice upon request
Moclobemide is a reversible inhibitor of monoamine oxidase-A (MAO-A) with IC50 value of 10μM [1].Moclobemide is a prototype of RIMA agents. It is found to possess antidepressant efficacy with less risk of fatal side-effects like hypertensive crisis. Moclobemide shows a weak but specific inhibition of MAO-A in the in vitro assay using rat brain homogenates. The IC50 values of MAO-A and MAO-B in the assay are 6mM and 1000mM, respectively. In ex vivo animal experiments, moclobemide produces an inhibition of 80% in the brain and liver. Additionally, the long-term administration of high doses of moclobemide is found to down-regulate β-adrenoceptors and increase the agonist binding affinity of α1-adrenoceptors. Moreover, moclobemide is rapidly and almost completely absorbed after oral administration. The bioavailability of moclobemide is about 50% after a single administration of 100 mg
商品属性:
| 货号 | CS-01Y68906 | 规格 | 10mM (in 1mL DMSO) 10mg 50mg |
| CAS号 | 71320-77-9 | 分子量 | 268.74 |
| 含量 | >98.00% | 别名 | |
| 分子式 | C13H17ClN2O2 | 化学名 | |
| 产地 | 国产 | 用途 | 仅供科研研究实验 |
抗逆滴加序列
每次向板内滴加抗原时,移液器滴头要与平面45度悬空,不要触碰到孔内的液体,由后向前依次滴加(即浓度由低往高滴加)。
抗感染反应期
抗原抗体在室温20~25℃下,必须反应30min以上,若环境温度低于室温,可将微量反应板置于恒温培养箱中,使二者充分反应。
旅游温度
磷酸盐缓冲液的pH值要在高压灭菌后进行滴定,往往在高压后pH值会有所改变,所以高压后再调一次pH值更为准确。磷酸盐缓冲液一经使用保存期不要超过3周。当pH<5.8时,红细胞会产生自凝现象;当pH>7.8时,图形洗脱加快,易造成肉眼观察产生误差;p H=7.2时,红细胞沉降最充分,图形最清晰。
当滴注 1%红细胞悬液时,应经常摇晃红细胞悬液,使红细胞均匀地分布在磷酸缓冲液中,以防止红细胞下降。
反应时间及温度
加入鸡红血球之后,反应板在室温(20~25℃)静置30~40min,对照孔血球下沉于孔底,即可判定结果。若室温达不到实验要求,需相应调整反应时间。当环境温度低于4℃时,红细胞发生自凝;高于37℃时,会发生反应物分离和红细胞溶血。
公司正在出售的产品:
| Recombnant Human TNFa/TNF-alpha, N-H | DEF8 Antbody Blockng Peptde |
| MNK2 Antbody Blockng Peptde | TR4 Antbody Blockng Peptde |
| DHDH Antbody Blockng Peptde | ACP3 Antbody Blockng Peptde |
| CT2 Antbody Blockng Peptde | HGD1C Antbody Blockng Peptde |
| GLE1 Antbody Blockng Peptde | DDT3 Antbody Blockng Peptde |
| phopho-MERTK (Tyr749) Antbody Blockng Peptde | EPHA4 Antbody Blockng Peptde |
| TXBP2 Antbody Blockng Peptde | AA1 Antbody Blockng Peptde |
| UCP-2 Antbody Blockng Peptde | Rho GTP酶激活蛋白24封闭多肽 |
| CPLX1 Antbody Blockng Peptde | DYNLT3 Antbody Blockng Peptde |
| VGF Antbody Blockng Peptde | DRCH1 Antbody Blockng Peptde |
| Phopho-NPM1 (Thr199) Antbody Blockng Peptde | CCDC59 Antbody Blockng Peptde |
| AR-CoV-2 (2019-nCoV) pke 2 (982A) Mutated Peptde | NR1D2 Antbody Blockng Peptde |
| ERp72 Antbody Blockng Peptde | Moclobemide (Ro 111163) Antbody Blockng Peptde |
| MUTCH 1 Antbody Blockng Peptde | MEX3A Antbody Blockng Peptde |
| ELMOD2 Antbody Blockng Peptde | phopho-HG (Tyr334) Antbody Blockng Peptde |
1.本蛋白酶抑制剂混合物为100×的储存液,使用时按照1:100的比例加入到裂解液中(例如,1ml裂解液中加入10μl蛋白酶抑制剂混合物),混匀后即可使用。根据需要,0.5M的EDTA也按照1:100的比例加入到裂解液中(如用于检测金属蛋白酶活性,则不宜添加EDTA)。含有蛋白酶抑制剂混合物的裂解液宜现用现配,不宜配制后冻存待后续使用。
2. 待所需的抑制剂添加完毕混匀后,就可以开始进行哺乳动物组织的裂解和蛋白提取。
风险提示:丁香通仅作为第三方平台,为商家信息发布提供平台空间。用户咨询产品时请注意保护个人信息及财产安全,合理判断,谨慎选购商品,商家和用户对交易行为负责。对于医疗器械类产品,请先查证核实企业经营资质和医疗器械产品注册证情况。
技术资料暂无技术资料 索取技术资料
Moclobemide (Ro 111163)
¥600 - 3200








