• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        Enrichment of PBMCs with monocytes

        互联网

        1139

         

        Enrichment of PBMCs with monocytes

        Contributed by Dr.A.Gratchev

        This protocol is used in our lab to reduce the costs of the cell sorting with MACS reagents. The cell suspension obtained after this protocol contains 40-70% monocytes. This cell suspension is than used for positive or negative MACS separation.

        Buffy coats to be used for this protocol must be fresh and produced without platelet depletion. The volume of buffy coat that we obtain from Red Cross is usually about 75 ml.

        Note: PBS should be without Ca2+ and Mg2+ !

        1. Dilute buffy coat to 150 ml with PBS.
        2. Prepare 2 Ficoll (Biocoll) gradients in Leucosep tubes (15 ml Ficoll per tube).
        3. Apply 30 ml of diluted blood to each gradient.
        4. Centrifuge 30 min at 400 x g without brakes.
        5. Collect the PBMC fraction and transfer it into a 50 ml tube.
        6. Fill the tube with PBS, centrifuge 10 min at 300 x g.
        7. Resuspend good in 50 ml PBS, centrifuge 10 min at 200 x g.
        8. Resuspend good in 50 ml PBS, centrifuge 10 min at 300 x g.
        9. Prepare continuous Percoll gradient (see below ).
        10. Apply all the cells on the Percoll gradient.
        11. Centrifuge 30 min at 400 x g without brakes.
        12. Collect enriched PBMCs and transfer into a 50 ml tube.
        13. Fill the tube with PBS, centrifuge 10 min at 300 x g.
        14. Resuspend good in 50 ml PBS, centrifuge 10 min at 200 x g.
        15. Resuspend good in 50 ml PBS, centrifuge 10 min at 200 x g.
        16. Determine the cell number, take an aliquot for FACS analysis and proceed with MACS separation.

        Continuous Percoll gradient preparation:

        1. ~undefined : 13.5 ml Percoll (Amerhsam), 15.0 ml MEM Spinner modification (Sigma), 1.5 ml 10x Earle’s salts solution (Biochrom)
        2. Centrifuge 10 min at 14000 x g without breaks in a fixed angle rotor.
        3. Carefully take the gradient out of the rotor.

        The gradient is ready to use now.
         

        ~undefined The tube should be able to resist centrifugation at 14000 x g.

         

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序