• 我要登录|
  • 免费注册
    |
  • 我的丁香通
    • 企业机构:
    • 成为企业机构
    • 个人用户:
    • 个人中心
  • 移动端
    移动端
丁香通 logo丁香实验_LOGO
搜实验

    大家都在搜

      大家都在搜

        0 人通过求购买到了急需的产品
        免费发布求购
        发布求购
        点赞
        收藏
        wx-share
        分享

        Sucrose Density Gradient Fractionation of Yeast Membranes

        互联网

        836

         

        • Grow a 2 ml culture, 24 hr. at 30oC in selective media
        • When culture is ready, use it to inoculate about 55 ml (50 ml plus 5 for O.D.600 readings) of selective media. Grow to mid-logarithmic
          phase (O.D.600 is about 1). This usually takes 10 hours (for 1ml of the 24 hr. culture into 50 ml media). It is helpful to inoculate 2
          different flasks--one with 1 ml of the 2 ml culture, the other with 0.5 ml of the 2 ml culture
        • Spin at 2750 X g. for 10 min. at 30oC
        • Resuspend in 100 ml pre-warmed YPD so that O.D.600 = 0.5 (50 ml of O.D.=1 culture into 100 ml total YPD)
        • If appropriate, after 1 hr add 2.5 uM alpha factor (421 ul of stock (1 mg/ml) to 100 ml of culture) (we want it present during the last
          hour of growth)
        • Wait 1 doubling period (about 2 hours) until O.D.600 equals about 1
        • Add 1 ml of COLD 1M NaN3 to 100 ml culture (we want 10 mM total conc.)
        • Spin down 3 x 109 cells (about 100 O.D. equivalents (100 ml of OD = 1): 2750 X g., 10 min., 30oC in lab clinical centrifuge
        • Wash 1x with 10 ml SK buffer in 15 ml falcon tubes (see recipe below).
        • Resuspend in 10 ml SK with 1 mg zymolyase and 28.8 mM Beta-mercaptoethanol to make SK:
          thaw zymolyase (kept at 5 mg/ml stock in SK at -20oC) at room temp, then spin 1 min at 14,000 rpm. Take supe.-- for 4 gradients, use 900 ul of supe, 90 ul of beta-mercaptoethanol and bring to 45 ml with SK (this recipe should be adjusted for the appropriate number of gradients--we want to conserve zymolyase--it's expensive)
        • Shake gently, 45 min, 60 rpm, 30oC

        FROM HERE ON OUT KEEP EVERYTHING AT 4oC

        • Centrifuge 500 x g, 10 min. 4oC.
        • Wash 1 x with 2 ml cold SK buffer
        • Wash again with 2 ml lysis buffer C (See recipe below)
        • Resuspend in 1 ml lysis buffer C and transfer to glass P-E tube (potter-elvejhem-- homogenizer tube)
        • Disrupt with 25 strokes of a motorized homogenizer on ice (go entirely in and out of liquid 25X)
        • Transfer to eppendorf tube, centrifuge twice (spin once then re-spin sup) at 500 X g. for 10 min., 4oC
        • Remove 100 ul of sup as "input." add 100 ul 2X SDS-PAGE sample buffer. Put in 100oC heat block for 10 min., then transfer to -20oC.
        • Add 650 ul of the sup to 606 mg (0.606 g) sucrose in a ultracentrifuge tube (this makes a 70% solution)--use tweezers to handle ultracentrifuge tubes, add "flea" (the tiny stir bar). Put a bunch of tubes in a small beaker and put the beaker on a stir plate in the cold room. leave at 4o until dissolved (around an hour)
        • Remove flea by taking a big stir bar and putting it against the outside of the tube, moving it upwards. Gently overlay with 1 ml cold sucrose solutions of 60%, 50%, 40%, 30%
        • Balance tubes with 30% sucrose solution (weigh them to confirm balance)
        • Spin in swinging bucket centrifuge for 16 hr (can go longer) at 190,000 x g (37500 rpm) in a SW55Ti rotor
        • Have microfuge tubes pre-labelled with 100 ul 4X SDS PAGE sample buffer
        • After spin is done, collect 16 samples of 300 ul each into 100 ul of 4x SDS-PAGE sample buffer.
        • Put at 100oC for 10 min, then freeze at -20oC--can store here indefinitely.

        RUNNING GEL

        • Pre-warm samples to about 37 oC for about 20-25 min. Vortex, spin at 14,000 for 1 min.
        • Pour gel: 1.5 mm thick, 8% SDS-PAGE gel with a long stacking gel--about 1/2 of the gel should be separating, and 1/2 stacking. Also use a 15 well comb
        • Load 20 ul of sup
        • Run at 50 volts for about 4 hr.
        • Transfer for 2 hr (or 1 hr 30 min) at 100V

        SOLUTIONS

        S/K (100 ml):

        1.2 M sorbitol (21.84 g/100ml)
        0.1 M KPO4 pH 7.5 (9.5 g dibasic (fw = 268) 1.99 g monobasic (fw = 136)

        filter sterilize!

        zymolyase buffer:

        to S/K buffer add:
        2 ul/ml of beta mercaptoethanol
        20 ul/ml of zymolyase (stock solution 5 mg/ml in S/K)

        spin before using!

        Lysis buffer C:

        20 mM TEA pH 8
        0.8 M sucrose
        1 mM EDTA
        1 mM DTT (add fresh)
        1 mM AEBSF (add fresh)
        10 ug/ml leupeptin (add fresh)
        10 ug/ml pepstatin (add fresh)
        10 ug/ml benzamidine (add fresh)

        mix first 3 ingredients and filter sterilize

        Sucrose:

        60 g sucrose + 5 ml 200 mM TEA + H2O to 100ml for 60% solution
        also prepare 50%, 40%, 30% (all also dissolved in TEA)

         

        ad image
        提问
        扫一扫
        丁香实验小程序二维码
        实验小助手
        丁香实验公众号二维码
        扫码领资料
        反馈
        TOP
        打开小程序