相关产品推荐更多 >
万千商家帮你免费找货
0 人在求购买到急需产品
- 详细信息
- 文献和实验
- 技术资料
- 保存条件:
见瓶身
- 保质期:
见lot
- 库存:
999
- 供应商:
嘉兴亦高
- CAS号:
56512-49-3
- 规格:
89802-500MG
Amino groups are common to many biological compounds and many amines used in pharmaceuticals. Most of these compounds show weak absorption in direct HPLC analysis with UV-VIS detection. However, strongly absorbing derivatives of amines can be easily detected by HPLC with high sensitivity even when present at low concentrations. Primary and secondary amino groups are usually derivatized as aromatic derivatives by nucleophilic substitution reactions using reagents such as arylsulfonyl chlorides. 4-(Dimethylamino)azobenzene-4′-sulfonyl chloride, a well-known UV-labeling agent, is generally used for the derivatization of N-terminal amino acids, imidazole derivatives, polyamines, etc. prior to their chromatographic determination due to the former′s capacity to covalently bind to the substrates.[1] Its derivatives typically absorb UV radiation between the range of 436-460 nm. This method of derivatization is regarded as superior compared to other methods owing to the simplicity of the procedure, high stability and reproducibility, best resolution of the analytes, etc.[2][3]
应用
4-(Dimethylamino)azobenzene-4′-sulfonyl chloride may be used to derivatize biogenic amines,[4] primary amino acids,[5] melamine,[1] and hydroxyproline and proline[2] extracted from various biological samples prior to their determination using high performance liquid chromatography (HPLC) technique to increase their detection sensitivity.
风险提示:丁香通仅作为第三方平台,为商家信息发布提供平台空间。用户咨询产品时请注意保护个人信息及财产安全,合理判断,谨慎选购商品,商家和用户对交易行为负责。对于医疗器械类产品,请先查证核实企业经营资质和医疗器械产品注册证情况。
文献和实验Liu SJ, et al.
Food Chemistry, 266, 275-283 (2018)
:Formerly listed as Type III 溶解性:溶于水,参考浓度2mg/ml 储存条件:2-8℃ From Sigma D1626 Salmon DNA 的配制: 组份浓度10 mg/ml Salmon DNA ;配制量约100 ml 配制方法: 1. 称取鲑鱼精DNA 2 g置于500 ml烧杯中,加入约200 ml的TE Buffer。 2. 用磁力搅拌器室温搅拌2~4小时
Carnoy's Fix: 6 parts 100 % EtOH 3 parts CHCl3 1 part glacial acetic acid Carmine Alum Stain: Place 1 g carmine (Sigma C1022) and 2.5 g aluminum potassium sulfate (Sigma A7167) in 500 ml distilled water and boil for 20 min. Adjust final
入20.9g MOPs,放在磁力搅拌器上溶解。再加1.86g EDTA二水二钠,放在磁力搅拌器上溶解。用1M灭过菌的NaOH 调PH至7.0(约用NaOH 40ml),用DEPC 处理过的去离子水定容至500ml,装入棕色瓶中,写好标签,室温避光保存。4、5 × 甲醛变性胶加样缓冲液(5×loading buffer): 配制10ml。预先配制水饱和的溴酚蓝溶液:在1.5ml 离心管中加入约0.1mg溴酚蓝,加入1ml DEPC水溶解,充分振荡溶解,离心,可见离心管底部有溴酚蓝粉末剩余,上层液体
技术资料暂无技术资料 索取技术资料







