产品封面图

甲型流感/乙型流感双重RT-PCR试剂盒(暂停)

收藏
  • 询价
  • KA&M BIO
  • 国产
  • BFS0495
  • 2025年07月11日
    avatar
  • 企业认证

    点击 QQ 联系

    • 详细信息
    • 文献和实验
    • 技术资料
    • 保存条件

      低温

    • 保质期

      详见说明

    • 库存

      99

    • 供应商

      上海圻明生物

    • 规格

      50次

    甲型流感/乙型流感双重RT-PCR试剂盒(暂停)上海圻明生物优势供应。更多产品资料欢迎免费咨询。

    One of the many important uses of PCR technology is that it can be used to label DNA probes with high specific activity. PCR technology has high specificity, and can synthesize probe DNA fragments in quantities within 1~2h if [α-32P]dNTP or other markers are added to the substrate
    dNTPs, the probe DNA can be well labeled during DNA synthesis, and the incorporation rate of the marker can be as high as 70%~80%. Therefore, PCR labeling technology is particularly suitable for large-scale detection and non-radiolabeling. The disadvantage of this method is that a specific pair of PCR primers is synthesized.
    Labeling can also be achieved by using small fragments prepared from probe DNA as primers.

    Solution preparation

    1. Prepare a stock solution

    Unless otherwise stated, all unused stock solutions should be divided into disposable aliquots and stored at -20 °C after preparation. Avoid repeated freeze-thaw cycles.
    1.1* Acid Stock Solution (125X):
    Add 20 μL DMSO to *ate (component B) to make a 125X* acid stock solution. 

    2. Prepare standard solutions

    *Salt standard solution
    Add 50 μL of 1 mM KH2PO4 (Component C) to 950 μL of deionized water or enzyme reaction buffer to give a 50 μM * saline standard solution (PS7). A 50 μM * saline standard solution (PS7) was taken and serially diluted 1:2 to obtain a serially diluted phosphate standard with deionized water or enzyme reaction buffer.

    3. Prepare a working solution

    Add 20 μL of 125X* stock solution to 2.5 mL of sterile H2O and mix well to make a working solution of *salt. Avoid potential Pi contamination. Note: Avoid direct exposure of *salts (component B) to light. Due to the high sensitivity of this assay to Pi, it is extremely important to use Pi-free labware and reagents.

    风险提示:丁香通仅作为第三方平台,为商家信息发布提供平台空间。用户咨询产品时请注意保护个人信息及财产安全,合理判断,谨慎选购商品,商家和用户对交易行为负责。对于医疗器械类产品,请先查证核实企业经营资质和医疗器械产品注册证情况。

    图标文献和实验
    相关实验
    • 流感病毒实验室检查技术

      被抗甲5型(H5)病毒血清抑制而不被抗甲1或抗甲3病毒血清抑制的甲型流感病毒),须立即上报国家流感中心,WHO总部或任一WHO流感协作中心。 2、霍乱滤液(RDE)处理标准抗血清去除非特异性抑制素 (可用WHO普通流感试剂盒提供的RDE) (1)用1ml蒸馏水溶解冻干甲5型(H5)病毒抗血清,溶解后的血清可于-20℃或-70℃保存。 (2)用25ml无菌生理盐水溶解RDE,分装包存。 (3)1份血清加3份RDE(0.1ml血清加0.3mlRDE),混合后37℃水浴过液。 (4)56℃

    • [交流]关于RT-PCR

      的所有的cDNA(理论上),还要用此产物做PCR 的模板继续扩增。如果用c方法,那么要去那里查它的序列呢?问题:在做RT-PCR遇到一怪现象,即对同一动物不同组织扩增同一段基因,结果从一种组织中可以扩出我的目的基因,条带非常的好,而另一组织在同样的条件下却得到许多非特异性的条带,尝试其他条件同样无法得到满意的结果,百思不得其解!(注:已肯定该基因在两种组织中都表达,且内参照在两种组织都可扩增出来)从这两种组织中提取的RNA的量是不一样的,我测过吸光度,差异还很大,会不会和这有关呢? 请高手指教!解答:1.RT-PCR

    • 【原创】RT-PCR实验方法总结大全

      以1×TBE为上下槽电泳缓冲液,加上电压后进行预电泳,如果用测序电泳装置,电压应达2000v以上,功率设定为100w,温度设为50 OC。待胶板温度达50 OC时,暂停电泳,准备加样。 (3)加样 将已溶解在加样缓冲液中的样品80 OC加热2min,立即加样到胶孔中,电泳1-2hr。(电泳条件同预电泳)。 (3)电泳结束后,打开胶板,用滤纸取下胶,覆上一层保鲜膜,放置于暗盒中,暗室红光下,压上一张X片,盖上暗盒,-70OC曝光1-3天。暴光结束后,将X光片显影、定影、水洗、晾干。 三

    图标技术资料

    暂无技术资料 索取技术资料

    同类产品报价

    产品名称
    产品价格
    公司名称
    报价日期
    询价
    上海圻明生物科技有限公司
    2025年07月12日询价
    ¥800
    上海彩佑实业有限公司
    2025年07月12日询价
    ¥4490
    上海博尔森生物科技有限公司
    2025年07月04日询价
    ¥2990
    上海笃玛生物科技有限公司
    2025年07月15日询价
    ¥2990
    上海泽叶生物科技有限公司
    2025年07月16日询价
    甲型流感/乙型流感双重RT-PCR试剂盒(暂停)
    询价